Climate Engineering Company does not only install and repair HVAC units but also offers a quality Preventive Maintenance Program. We can minimize the cost on repairs by inspecting and identifying the trouble before it becomes a costly & tedious repair job.

There are certain Air Conditioning and Heating problems, which could lead to :

Dirty filter, evaporator, condenser and blower makes your unit work harder, which can increase your electricity consumption by 50 percent.

It has been found that as much as 80 percent of all the Air Conditioning compressor failures could be done away with if the problems leading to the failure were rectified and repaired at an appropriate stage

Just 1/100 of an inch of dirt or film on an evaporator coil can reduce its efficiency by 5 percent

Timely checks and proper inspection will not only cut down the high cost of repairs and premature replacement of the equipments but would also enhance the efficiency and life of the equipment.

Getting your HVAC system checked at a regular interval is an important process and helps your system go an extra mile with good running condition. 
Therefore it is imperative to hire experienced and expert professionals who can give unbiased suggestions and service that is prioritised and personalised.

Climate Engineering Company gives four routine inspections, which take care of checking and servicing of the unit per Annum

› Wash air cooled condenser coils.

› Acoustic Insulation.

› Check thermostat; level & calibrate where needed.

› Brush clean evaporator coils.

› Blow out and flush drain lines.

› Check electrical connections.

› Check amperage draw on compressor, motors & electric strips.

› Check voltage.

› Check refrigerant charge & levels.

› Check refrigerant pressures.

› Oil motors (if accessible).

› Check Temp difference across indoor coils.

› Check Temp difference across outdoor coils.

› Record all service data.

› Overall visual inspection.

› Check refrigerant pressures.

› Check refrigerant pressures.